请教，既然只需要短接两个引脚，为啥需要做一块假的卡，能否直接用铜线在插槽上短接一...
查看之前的国外论坛资料新的G10 Plus到了，被税海关邮件自提。默认的bios 里面是开启不了iLO的，即使设置为share 网卡的模式，也无法使用。现要找一个 PCIE卡来破坏，有显卡，网卡，nvme转接卡，还有一个之前咸鱼上买的hp flom转接卡， 多了一张，价格不高，十...
还有 3 人发表了评论 加入5306人围观计算机硬件
Garmin gps 切换USB MTP模式
lixiaoyao 发表于2017-09-30 浏览2906 评论0
Some automotive devices use Media Transfer Protocol (MTP) for connecting to your computer. MTP provides a more secure environment for the important system files on your device.
MTP connectivity requires the following.
Windows XP with service pack 3 or later.
Windows Media Player 11 or later.
计算机硬件
garmin gps 进入 debug 模式
lixiaoyao 发表于2017-09-30 浏览2819 评论0
The "debug menu" (also called the "maintenance mode") on a Garmin Nuvi 750 is a utility that allows you to reset your device back to factory settings.
You can reset any addresses saved to the device as well as custom points of interest, such as restaurants, hotels or whatever.
You don't need to do anything special to enter this menu on the device, you simply just need to press in the right location at the right time.
Steps to Enter Debug Menu
1.Turn off your Garmin Nuvi 750.
2.Press and hold your finger in the lower, right-hand corner of the Nuvi 750's touchscreen.
3.Turn on your Nuvi 750 while continuing to press on the unit's screen. This will launch the debug menu on the device.
4.Press "Yes" or "No" when asked if you want to restore your device factory settings. You can also press the other button on-screen to continue into "maintenance" or "debug" mode.
Exit the Debug Menu
To exit out this special menu on your Garmin Nuvi 750, simply turn the device off and turn it back on again.
Garmin 3597
进入调试模式 ， 长按右上角 电池位置5秒